OS-WIRE OPERATOR CONSOLE (OS8735/1) Maximize

OS-WIRE OPERATOR CONSOLE (OS8735/1)

OUT OF STOCK - Contact us for more information

More details

16 other products in the same category:

Operator Console with OS-Wire interface for 10/510 CNC (OS8735/1 interface board)

The console is equipped with the following controls:

  • CYCLE START, HOLD and RESET luminous buttons
  • Encoder type selector to set feed rate (0-125%; 20 steps/rev)
  • Encoder type selector to set spindle rotation speed (75-125%; 20 steps/rev)
  • Encoder type selector to set feed rate in manual and/or rapid mode (0-100%; 20 steps/rev)
  • Operating mode selection (Automatic, Semiautomatic, MDI, Manual, Jog, Axis reset) luminous buttons
  • Digital I/Os (7 digital inputs and 7 configurable digital I/Os) are available, on a connector at the back of the console, which you can use to customise the console, which can be managed by a PLC and can be used for buttons and telltales.
  • 12x16-diameter holes are also available, and  1x22-diameter hole for the emergency button.
     

Dimensions: 484 x 132 mm
24VDC only power supply

Note:
the console is enabled/disabled by the PLC. The PLC can also change the default values for the feed, speed, manual and/or rapid feed selectors. The values that can be changed are: step size, number of steps per rev and selector rotations to go from the minimum to the maximum value.

You can fit several consoles to a system and activate them simultaneously

Ads



OSAI cnc S.r.l.

Via Jervis, 11
10015 Ivrea (TO)
ITALY

eshop@osaicnc.com
sales@osaicnc.com
+39 0125 1906267

LOGISTIC SITE

Via Caluso, 10
10010 Barone Canavese (TO)
ITALY