CANOPEN COMPACT OPERATOR CONSOLE (OS8730/1)

CANOpen WinMedia Compact Operator Console for 10/510 CNC (OS8730/1 interface board)

The console is equipped with the following controls:

• CYCLE START, HOLD and RESET luminous buttons
• Encoder type selector to set feed rate (0-125%; 20 steps/rev)
• Encoder type selector to set spindle rotation speed (75-125%; 20 steps/rev)
• Encoder type selector to set feed rate in manual and/or rapid mode (0-100%; 20 steps/rev)
• Operating mode selection (Automatic, Semiautomatic, MDI, Manual, Jog, Axis reset) luminous buttons
• Digital I/Os (7 digital inputs and 7 configurable digital I/Os) are available, on a connector at the back of the console, which you can use to customise the console, which can be managed by a PLC and can be used for buttons and telltales.
• 1x22-diameter hole for the emergency button.

Dimensions: 305 x 134 mm
24VDC only power supply

Note:
the console is enabled/disabled by the PLC. The PLC can also change the default values for the feed, speed, manual and/or rapid feed selectors. The values that can be changed are: step size, number of steps per rev and selector rotations to go from the minimum to the maximum value.

You can fit several consoles to a system and activate them simultaneously